![]() I suppose Reaper will correct this by imposing an appropriate delay before mixing the tracks. (The sum count of requested PDC samples is not shown anywhere). I'm not sure that this is really necessary as long as the sum count of PDC is lower than a buffer. This obviously is what the two PDC numbers shown indicate (as long as only using a single plugin).Īnd I can confirm that the total PDC buffer count used for PDC compensation (seemingly shown right of the "/" increase with each plugin requesting only a single sample of PDC (shown left of the "/"). I remember to have tested that Reaper does handle this as expected.īTW1: Regarding testing: the PDC is only fully updated when the playback is stopped and then started.īTW2: As audio is always handled in complete buffers, using a PDC of a single sample needs handling a full buffer of advanced execution and applying a delay og the count of samples in a buffer minus 1 afterwards. Here you can set the PDC it reports (in negative delay mode). ![]() ![]() ![]() You can try this with the +/- delay from ReaPack. But what I observe is that Reaper apparently adds one buffer of PDC for each plugin in a sequence, just as mentioned above.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |